Open topic with navigation
Extracting NuoDB from an installation
tar file is useful in the following situations:
When you install NuoDB from a
tar file then NuoDB is not automatically started when the system comes up. After each system restart, you must manually start NuoDB services.
To use a
tar file to install NuoDB:
etc/nuodb.configfile. This file will be overwritten.
tarfile from the directory to which it was downloaded. In the command line in the example below, you would replace
n.n.n.nwith the NuoDB version number in the filename you are operating on.
In the following examples, you would replace
install_dir with the directory in which you are installing NuoDB:
tar xzvf nuodb-ce-$
tar xzvf nuodb-n.n.n.n.linux.x86_64.tar.gz$